Phoenix awardbios cmos setup utility manual

#Phoenix awardbios cmos setup utility manual manual

This is the resting position for the hard disk head when the hard disk motor is switched off.Дefine or set the number of sectors per track. This parameter defines the so-called landing zone or park cylinder. This parameter specifies the cylinder from which a difference in the information density is to be expected. Write pre-compensation, required for older hard disks. Next, check the documentation for your motherboard. Touch the chassis of the casing with a metallic object to discharge static electricity. The following process will reset the BIOS settings to default: Turn off your PC, unplug the power cable and open your system unit. Depending on the BIOS version and the manufacturer it varies between 1,024 and 16,384 cylinders.Дefine or set the number of heads. To recover the BIOS password, you have to move a jumper on the motherboard. This value is calculated from the individual hard disk parameters.Дefine or set the number of cylinders. The following parameters are automatically determined and displayed. The following options are available for setting the hard disk access mode: If the number of cylinders (CYLs) on the hard disk exceeds 1024 and DOS cannot support it, or if your operating system does not support LBA mode, LARGE mode should be selected. The BIOS supports the INT 13h extension function that enables the LBA mode to manage hard disk drives with a capacity of more than 8.4 GB. It translates cylinders, heads and sectors into a logical address for the data location. This mode uses a different method for calculating the position disk data to be accessed. The older LBA (Logical Block Addressing) mode can support hard disks with a capacity of up to 8.4 GB. This mode uses positions for data access that are specified via cylinders (CYLS), heads, and sectors. Normal (standard) mode supports hard disks with a capacity of up to 528 MB. Setting options: CHS, LBA, LARGE, or Auto.

This option can be used to select the operating system for the hard disk.

#Phoenix awardbios cmos setup utility manual manual

Manual (the hard disk is addressed with the set parameters).Auto (auto-detection during each boot process) Select Save & Exit Setup, and press Enter key.None (no hard disk connected to this bus connection).This parameter is used for configuring the IDE bus. After a few seconds the physical data of the connected hard disk should be displayed in the lower section of the menu. в†‘ в†“ в†’ в†ђ :Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:HelpДЇ5: Previous Values F6: Fail-Safe Defaults F7: Optimized DefaultsДЄutomatic detection of the hard disk is initiated by pressing the key. The hard disk data (size, number of cylinders, heads, sectors, pre-compensation and home position of the heads when the disk is switched off) are displayed automatically for the connected hard disk. This menu is used for setting the data of the first hard disk connected to the IDE bus as master.